Using Noah live

[wayne]

ok, just swapped my pulsar 1 for a noah
haven't got it yet, but am looking forward to implementing it into gigs and the home setup.

What's your feelings about it onstage?

Anybody used vocodiser live?

General thoughts? legros, marcus?

[Nebukadneser]

I am going to use my 3 days old Noah EX for the first time live tomorrow. I will be changing synths manually in Single mode and I will be using my Yamaha CS1x keyboard MIDIed to Noah. No computer involved.

I have encountered a problem:

I have fixed 4 knobs on the Yamaha respectively to Continous Controller no 3, 4, 12, and 13 and I want to have those assigned to Cut off, resonance and 2 more on each Noah Synth.

I have managed to assign it successfully on the Vectron PLayer, but I cant manage to assign the same CC numbers to parameters on ProTone, Minimax and Lightwave. Is it not possible to assign the same CC number to more than 1 synth?

Regards

Neb

<font size=-1>[ This Message was edited by: Nebukadneser on 2004-12-01 06:10 ]</font>

[wayne]

i think you need another midi controller, Neb.

it's not possible in scope, so you probably need more knobs

good luck with the gig

[Nebukadneser]

I'll be using the synths 1 at a time in Single mode, so I expected that it would be possible to use the same Controller numbers and assign those to parameters on all synths. I think I can do so in Scope?

Apart from that - the Noah is fantastic, I am most surprised and extremely impressed by the B2003, which surpassed my expectations after using NI B4 for a while. The B2003 IS a tonewheel organ!

Regards Neb

Setup:
PIII 1.4 Celeron Tualatin
NOAH EX
Pulsar1
Luna2
24/96 Break out box
E-mu 6400 Ultra
Emu Esi 4000
Yamaha S80
Yamaha C1x

[wayne]

aah, misunderstood you - yes that's possible in scope - could be worth an email to cw

[Gordon Gekko]

yo dude!

weeelll, we didn't use it live sould be a reliable module though, it sounds great and it provides a lot of power when it comes to transiting between songs. anyway congrats!