PlanetZ forums - scopeusers.com

you can record all your tracks in one stereo track by the bus provided in xtc mode (or a bus that you ve created in your xtc def.pro between the asio io devices)
and then when you make your final mix you can record it on the master track that you can bounce in non real time.

i used to work with ...

nobody here

yesterday i reinstaled all the scope

and guess what?

i have the same troublshootings

please help me what i have to configure


up up up

in pure asio xtc mode i don't have any trouble shooting

but maybe i have to reinstal all the card to take in charge the new features of the jumper

more of this i 've built another xtc folder and i've moved some plug ins and have built some as the vinco and others that i don't remember

so we will ...

@ h rave i think that you could make optimization

because me with a single sope project i can have three or four instruments and some plugins too without crackles in pure xtc mode

so if you have a P4P800 i think that you should look at the pci latency in the bios and try to put a fix latency in ...

i m sorry but it is not the question

before, i use the scope in asio xtc and the tascam 1884 was instaled only for remote of nuendo (in mackie control mode by firewire)
i routed the signal by adat to the tascam for monitoring and there i could put SOME plug ins and instruments with 6ms of latency ...

vst system link only work with ADAT its a shame but

all i read about that in forums is that only adat works

me i had the same problem and only adat works

maybe someone have vst system link by spdif or aes but they are luckyt for me

so now my system works but i've lost one adat channel because ...

hi

i put the bridge between pin 2 and 3 of the sync crd connector
as it was explain on a tips and tricks

so now i have the xtc running without scope asio and i can run
nuendo with a tascam FW 1884 and have a plugin xtc OR an instrument xtc

and the audio is drived by the tascam

i can bounce it ...

up

hello

i 'm building a daw with pulsar 2+ ,a tascam 1884 ,adda 8000 etc.
i need to have wordclock on the scope to connect it to a black burst

is there a aes ebu to wclck sync adapter
or should i buy a sync plate

thanks a lot

up

hi
i use a pulsar2+ and
i d'on't have any aes ebu module in xtc project
i just have spdif module

where could i find this module or which modification i have to do

thanx

jon

thanx a lot

if i have understand raid is not a good idea
but put the system to the raptor it is good?

sorry for the area where i put my topic i didn't know

hello

i'm running scope 4.0 with pulsar2 + pci board
on an asus A7N8X-E deluxe, amd 2800+ barton, 2 GO dual ram 400,
80 GO ide 7200rpm maxtor system drive,
200 GO sata1 7200rpm maxtor project drive
it works very good
but
i have a raptor 74 go 10000 rpm that i would use as system disk
and a new wd ...