well you know I must have more questions
I want to set an lfo to sweep a filter between the values I set, so I want to set a high and low limit on the filter and sweep between that. The thing is that the lfo likes to go from positive to negative and overiding the limits I set so it pushes the filter past where it should go. How can I make it stay on the positive side sweeping within limits?
lfo filter sweep
Re: lfo filter sweep
lfo_out * 0.5 + 0.5 = range [0;1]Jah Servant wrote:well you know I must have more questions
I want to set an lfo to sweep a filter between the values I set, so I want to set a high and low limit on the filter and sweep between that. The thing is that the lfo likes to go from positive to negative and overiding the limits I set so it pushes the filter past where it should go. How can I make it stay on the positive side sweeping within limits?
You could use the Mix 2 module for that - remember that 0.5 is 1073741824
If you need another range than [0;1] then scale the values 0.5.