Page 1 of 1
Posted: Mon Jul 28, 2003 7:02 pm
by Ricardo
Is it possible to hook up 3 cards if they are Pulsar 1, SRB and Luna 2?
Cheers
Posted: Mon Jul 28, 2003 10:07 pm
by garyb
yes.
Posted: Mon Jul 28, 2003 11:17 pm
by Ricardo
Thanx Gary,
Just had to check. Looks like my DSP is going up 4. Yippee!
<font size=-1>[ This Message was edited by: Ricardo on 2003-07-29 00:18 ]</font>
Posted: Tue Jul 29, 2003 1:42 am
by w_ellis
I think it depends what sort of SRB you have (4, 6 or 15 dsps?)...
Cheers,
Will
Posted: Tue Jul 29, 2003 2:22 am
by garyb
they should all work.
Posted: Tue Jul 29, 2003 3:26 am
by mr swim
You would just connect the STM cables to all three for the one with the fewest connections, connect up any spare on the second to smallest board, and leave any on the 15chip SRB board that didn't have counterparts in the others free . . .
Posted: Tue Jul 29, 2003 8:44 am
by Ricardo
Thanx to you all,
Just to let you know, it's a 6 chip SRB. I guess the Pulsar 1 will stay the host board,so do I need to add anything to my CSET ini.? Any particular IRQ priotities to think about?
Any suggestions?
Posted: Tue Jul 29, 2003 10:39 am
by Mr Arkadin
Make your SRB or Luna II the 'host' or first board, so as to take advantage of the lower latency figures you can get with post-Pulsar1 boards.
Mr A
<font size=-1>[ This Message was edited by: Mr Arkadin on 2003-07-29 11:40 ]</font>
Posted: Tue Jul 29, 2003 7:10 pm
by Ricardo
Thanx Mr A,
My SRB is the host at the mo. What I meant to say was I won't be using any I/Os on the Luna, only on the P1 (I think I used the wrong words.)