Page 1 of 1
Posted: Tue Jan 21, 2003 3:29 pm
by Damoo2000
When I load Cubase SX in XTC mode I get the message ' Powersampler cannot be used in xtc mode' which I have to click on to coninue loading SX. Does anyone know how to get rid of this ?
Posted: Tue Jan 21, 2003 4:48 pm
by siberiansun
did you install SFP 3.1a - 3.1c? if so did you choose "install XTC"?
if so did you check "enable XTC mode" in SFP -> settings -> global?
Posted: Tue Jan 21, 2003 4:53 pm
by Damoo2000
Yes.
XTC works fine in SX. it's just the message at the begining. I can live with it but it would be nice to go straight into SX without it pausing for the message !
Posted: Tue Jan 21, 2003 5:09 pm
by siberiansun
well beats me, i get a l m o s t the same message when opening logic with SFP running, you know "XTC plugins not avalible...." for obvious reasons.
hope someone else here can help you.