Page 1 of 1

Posted: Mon Dec 30, 2002 10:57 am
by kensuguro
is there some way to monitor the control signal? (like a VU, but just in numbers) So, if I'd connect the device to an LFO out, then the numbers would oscilate.. or even easier, if I connect it to a constant number module, the numbers get displayed as I move the slider. I'm looking for an easy way to monitor these signals. This would definitely be helpful.

Posted: Thu Jan 02, 2003 12:17 pm
by at0m
Here you go, Ken :wink: