Page 1 of 1
Posted: Tue Dec 17, 2002 8:59 am
by erezx
hey all - just bought the luna 2 ...
1.what is the prffer irq latency u work on ?
2.what is the preffer ullli i should put
(working on 44.1 hz )
thanx
Posted: Tue Dec 17, 2002 9:27 am
by marcuspocus
A1: Any IRQ which is not shared with anything else, preferably IRQ5 or IRQ9
A2: lowest you can without clicks&pops.
From 3ms to 7ms your pretty safe with asio.
With WDM driver, i really don't know, some application can go down to 11ms, other can't seem to work properly with anything lower than 25ms...
Posted: Tue Dec 17, 2002 12:53 pm
by erezx
gee thanx -
i ment the irq latency time - which i configured on 64 :-0 - hope it's good .
also took the ulli 2 7 ms ...
on 44.1 khz ....
hope im doing good
10x
Posted: Tue Dec 17, 2002 1:57 pm
by marcuspocus
If it's working, then it's good!
Have some fun with your card now, and post some music here on planetZ!
Posted: Wed Dec 18, 2002 4:26 am
by erezx
well since - now my pc stands on :
-pci latency on 64
-ulli on 7 ms
-also tried LUNA priority on low &
SX priority on normal .
Well SX crushed from some reasons -
can't tell u why ( i guess i was 2 stoned )
Posted: Wed Dec 18, 2002 11:57 am
by erezx
ok - problem # 1 ....
i use yamaha sx and he sends midi in
(donno if it's connected - heppend
just right after i pressed the keboard )
i get blue screen saying
irql ...... latency ..... or equall ...
should i raise or gain my irq latency ??
( now it's 64 )
10x
Posted: Wed Dec 18, 2002 6:23 pm
by Herr Voigt
Should be no problem of PCI latency. You should change this only if you use several instances of MasterVerb or if you use fat multisamples with high polyphony. Then if it crackles or you have dropouts, try a PCI latency of 96 or 128.
Greetz, Thomas
Posted: Thu Dec 19, 2002 6:03 am
by erezx
tahnx
back 2 32
works great