Page 1 of 1
Posted: Sun Oct 06, 2002 2:23 am
by WayneSim
I'm running scope 3.1 and have a pulsar 2 and Luna 2. Also I have gigastudio 2.50.
My problem is this: In gigastudio it doesn't reconize my creamware cards as GSIF cards. In the hardware/routing section I can't get pulsar 2 to be found. I can run midi from SFP to giga no worries. But I can't run the audio in SFP becasue giga will not ouput to SFP. Everything is pluged in fine. I get level in giga fine, but it won't come though to the GSIF source in SFP.
<font size=-1>[ This Message was edited by: waynesim on 2002-10-06 23:51 ]</font>
Posted: Sun Oct 06, 2002 3:18 am
by marcuspocus
What OS? XP?
Need giga 2.51 minimum for it to work under W2K or XP...
Posted: Sun Oct 06, 2002 3:22 am
by WayneSim
XP pro with the lastest updates.
Gigastudio 96 v 2.50
I'll try and update it. But are you sure this will fix it?
Posted: Sun Oct 06, 2002 4:22 am
by WayneSim
Downloaded Giga v2.53 and it didn't help.
Gigastudio will not reconize my creamware cards as GSIF compatibale. I run the tests in giga and it will not detect the pulsar 2 as a GSIF card. It picks up the midi and wave driver info, but no GSIF.
Please HELP if you can.
Posted: Sun Oct 06, 2002 10:55 pm
by WayneSim
bump
Someone must be using gigastudio with SFP on Win XP.
Posted: Mon Oct 07, 2002 2:20 am
by woodstock
I'm running SFP 3.1c and GigaStudio 2.5x together on my pc with XP and it works well,
but with different cw-cards (Pulsar I, Scope SRB).
Maybe a silly question, but do you do start SFP first, open a project with the gsif-module connected to a mixer and afterwards start GigaStudio ?
Posted: Mon Oct 07, 2002 3:47 am
by WayneSim
Yes I do everything right. SFP first, loading GSIF souce into mixer. Then start Gigastudio. Then I try everything else.....
I really don't know what else to to. I'm Downloading 3.1c now. But I don't think that will fix it.
Anyway please tell me more about your giga set-ups. In the hardware/routing section of giga. I can't seem to get pulsar as a GSIF card.... ???
Posted: Mon Oct 07, 2002 7:02 am
by WayneSim
YES!!!!!!!!!!!!!! YAHOO
I finally got it working.
Here's what I did.
1)Updated to SFP 3.1c
2)Uninstalled Gigastudio *RESET computer*
3)Ran Scope (Gigasampler preset)
4)Installed Gigastudio *RESET computer*
5)Ran Scope (Gigasampler preset)
6)Ran Gigastudio..... AND IT FINALLY FOUND my pulsar 2 as a GSIF card..........
WOO00 what a GIGA experince!!!!!
FINALLY............. I'm never going to sleep again, cause i'm having soo much fun.
Thanks everyone