Page 1 of 1
Posted: Sun May 26, 2002 8:35 pm
by djamir
hello im using Luna II amd logic 5.1.
if im using something like 5 audio channel then i allways get error messege that say system overload and the sound stop.
how can i fix it?
im using windows 98 SE
thanx
Posted: Mon May 27, 2002 1:34 am
by Tony B
Try checking the Larger Disk Buffer Box. If it continues check the Larger Process Buffer Box. In Syncronization Settings under Audio select External or Free.
Posted: Mon May 27, 2002 3:50 am
by djamir
i try thet and i still get this errors,
do you know any thing else that i can do?
Posted: Mon May 27, 2002 7:06 am
by Tony B
Check Luna settings in control Panel. Make sure 8 in 8 out. No more.
Posted: Mon May 27, 2002 7:35 am
by paulrmartin
On 2002-05-27 02:34, abre11 wrote:
In Syncronization Settings under Audio select External or Free.
I know where those settings are found. There is no external or Free though...
Posted: Mon May 27, 2002 8:19 am
by Tony B
I am using Version Logic 4.81. Are the general settings not the same as Version 5?
Posted: Mon May 27, 2002 8:57 am
by paulrmartin
In the General tab
Sync mode choices are:
Internal
MTC
Midi clock
Manual
No choices to be made under the Audio tab except for byte-rate settings
Unless I set the Validate MTC setting to "Jam sync" in the General tab?
Posted: Mon May 27, 2002 9:07 am
by Tony B
OK. Thanks. It seems to be different.
Posted: Sat Jun 01, 2002 7:10 am
by nunozzy
In my case, I have optimised everything in my system and I still had this message until I desactiviate in the bios the two serial ports.
Posted: Sat Jun 01, 2002 9:54 am
by Tony B
Where do you have the Logic key attached?
Posted: Sat Jun 15, 2002 10:22 am
by nunozzy
I do not have any Logic keys as I am using Logic Audio Silver. (only a CD check from time to time)
BUt I presume that Logic Audio Gold or Platinium does have an USB dongle, right ?
So in my case it would work as my two USB ports are still active (I am using a midi interface MT4 from Logic)