Page 1 of 1
Posted: Tue May 14, 2002 9:04 am
by lozt
I was just wondering if any1 could help with a problem with my 3.1 software I have loaded up the new software but when I go into the pulsar program and start a new project I cannot find the synths on my screen I have went through the manual but cannot find any info on this. If this is me being dumb I apologise in advance, but any help would be grateful
cheers
Thompsy
Posted: Tue May 14, 2002 9:17 am
by subhuman
When you installed SFP did you enter your keys? I suggest you login to the "My Page" section of the Creamware website, download your allkeys file, and import that during SFP install. You can safely install overtop your SFP, backup any presets, projects, etc just in case.
Posted: Tue May 14, 2002 9:55 am
by lozt
Cheers Subhuman, I have already used the allkeys file while loading the new sfp that is why I am lost on how to find the synths. Do you have any other ideas on this problem
Posted: Tue May 14, 2002 10:00 am
by subhuman
Did you (Right Click) on Live Bar, Synths > (list of synths) to load one, or did you find a list of synths in the pulldown menus at the top of the Routing Window (View > Project Window) where you can drag them in...
What type of card do you have, and what card did you install for? If you have Luna, you have no included synths, you must copy your devices from your previous install or redownload them. If you have Pulsar or SCOPE double check your installation (run the install again), be sure your Synth Package 1 or 2 keys are entered...
Posted: Tue May 14, 2002 10:00 am
by at0m
The devices may got lost in the install, but they are in the folder you installed it from sfp_v3_1Devices...
You could copy sfp_v3_1Devices (source installation folder) to ie. c:sfpDevices
Posted: Tue May 14, 2002 10:15 am
by lozt
Cheers Sub, I have just run through the install again I had not fully watched what I was doing and did not change from luna to pulsar on the start up
Cheers again
Thompsy