PlanetZ forums - scopeusers.com

Hello,
I have luna 2.5 with sts3000-device installed on PS-card and want to upgrade till luna 3.
So I bought a new luna-card.
I removed the "old" PS-card and put the "new" card in place of it.
After install the new luna3-software everything works except the sts3000-device.
The activationkey is invalid.
Does this mean i have to leave the "old" PS-card in the system and put the "new" luna-card next to it?
I don't have a S/TDMcable.
Any help is more than welcome!:o

Get an STDM cable, install both cards, and you should be good! And then you will have 6DSP, and all the I/os of both cards, as well, along with STS.

<font size=-1>[ This Message was edited by: subhuman on 2002-05-02 10:26 ]</font>

Thanks for the advice, I take it.
Buth is there no way to install my Powersampler(or sts3000) + luna3-software with just one card?

Yes, if you buy Luna3 software for your PowerSampler card, or buy STS-3000 for your Luna card...

Kim.

Or if you go through the pain of transfering the STS to your other Luna which takes 1-2 weeks, during which you won't have access to your DSP system... maybe that would work, but not positive as it's the PowerSampler and not "straight STS3k" you will have to email Creamware Germany support@creamware.de with your full details including both serial numbers and the key for the plugin.

<font size=-1>[ This Message was edited by: subhuman on 2002-05-02 14:43 ]</font>

Okay,
I won't do that, think its better to install the two cards and ask Creamware for the optional S/TDMcable.
Thanks for reply!

Creamware can be a little show sending STDM cables, they really prefer if you work with your Creamware dealer on this, so if you bought your card from a dealer or shop, ask them first, they should be glad to send you one...