Posted: Mon Mar 04, 2002 6:53 pm
Second generation CW cards run XTC in non-ASIO mode. This is also why Pulsar1 gives 'Cannot run in Accelerator Mode' pop-up.
This was confirmed by Ingo Raven (from Creamware) on yahoo groups. I quote:
atomic.
_________________
<font size=-1>He who always lays on the floor will never fall down.</font>
<font size=-1>[ This Message was edited by: atomic on 2002-03-13 18:00 ]</font>
This was confirmed by Ingo Raven (from Creamware) on yahoo groups. I quote:
I'm using an all-Creamware soundcard setup, but it may interest some of you.> So I can have my MOTU 828 as my ASIO driver and still load XTC Instruments
> into the Pulsar II card ?
>
> Regards,
>
> Andy
> http://www.subsymphonic.com
Yes.
Ingo,
CreamWare
atomic.
_________________
<font size=-1>He who always lays on the floor will never fall down.</font>
<font size=-1>[ This Message was edited by: atomic on 2002-03-13 18:00 ]</font>