PlanetZ forums - scopeusers.com

Hi all
I'm using a Pulsar 1 + Creamware A16 ADAT ADC-DAC converter. My Pulsar
is set as master and A16 as slave at 44.1 Khz. All the A16 inputs work OK,
but the outputs don't: they work properly, but periodically, every minute or
so, all the sound dissapears for 1-3 seconds; then I can hear the signal
again, and then again it dissapears for 1-3 seconds... I don't know where is
the problem here... please help me!

Thank you in advanced
Xabi
xblanco@mundo-r.com

Subject: Re: A16 out do not work properly... HELP ME PLEASE!

For playback through A16 outputs you must put it as MASTER and Pulsar board as SLAVE

Subject: No...

Thank you for your reply. I tried that but If I set the A16 as master and Pulsar as slave, definitely I don't hear any sound from the A16 outputs

Subject: Re: No...

This what CW has told me near 1 1/2 year ago when I suffered the same problem.

It has a logic, due A16 in master, means that A16 clock control the playback process.

Do you know that if you are using a mixer with unbalaced inputs, the plugs must be inserted at half way?

The TRS connectors are non standard due have the wires inverted.

Subject: A16, no output

My A16 worked same, before i sent it to Creamware to repair. It was the problem with the board of A16. About master and slave, its doesn`t meta what it is, but if U switching it to master there problem with timing of STS series sampler, it get the about 25-30 ms latency (may be it`s on my system only, im not sure). My configuration is
Pulsar+SRB+Luna.