PlanetZ forums - scopeusers.com

Posted: **Mon Feb 18, 2002 9:29 am**

I go to the IDE/ATA controllers in device manager, it is set to DMA if awailable, but current mode is PIO. I just copied 2,5GB - and it took ages.

Immanuel

Posted: **Mon Feb 18, 2002 9:33 am**

List your motherboard

Posted: **Mon Feb 18, 2002 9:46 am**

ECS k7s5a

Posted: **Mon Feb 18, 2002 10:48 am**

Did you install the <a href=http://www.sis.com/support/driver/index.htm>drivers</a> for your board? Maybe updating IDE driver enables DMA for you.

Posted: **Mon Feb 18, 2002 11:23 am**

Hi again

I am sorry, that this ended out in a parallel discussion. As stated in the other thread I found this site http://forum.ocworkbench.com/ocwbcgi/ul ... 4&t=002018, wich explains, that I had to run siside to be able to use DMA under winXP.

Boy, does that make a difference - I just recopied those 2,5GB, and now it was faster, and I could open Opera quicker than before while doing the copy. I was somehow of the impression, that winXP would find about turning on DMA by itself.

Immanuel

Posted: **Mon Feb 18, 2002 11:35 am**

<i>I was somehow of the impression, that winXP would find about turning on DMA by itself. </i>

It does on all i8xx intel boards and AMD76x boards. And I think even VIA boards...

<font size=-1>[ This Message was edited by: subhuman on 2002-02-18 11:36 ]</font>

PlanetZ forums - scopeusers.com

How do I make winXP understand I want DMA?