Page 1 of 1
Posted: Mon Dec 18, 2000 3:19 am
by Lotuz
I've tried to install the STS 4000 device on my new PC (PIII 800 MHz 256 MB Asus CUSL2-C mobo) with the same authorisation key I got from CreamWare when I installed it on my last PC. Now all of a sudden I get this error message:
"MIDI2PC: Unknown external symbol 'os_irqAck. This may be the result of an installation error or version conflict."
I've also tried to install it on another PC and I get the same error message.
What am I suppose to do?
Lotuz
Posted: Mon Dec 18, 2000 8:01 am
by DJKrooz
Subject: Re: MIDI2PC error message
This may sound obvious - but have you reinstalled pulsar again?
as far as i know when installing a new device you must install the device - activate it, then re-install pulsar back over the top.
Try that - fingers crossed it'll solve yer problems.
All the best
Krooz.
Posted: Tue Dec 19, 2000 12:07 am
by Lotuz
Subject: Re-install Pulsar II after installing new device?
"As far as i know when installing a new device you must install the device - activate it, then re-install pulsar back over the top."
Are you sure about this? The installation of the STS 4000 on my previous PC went perfectly without re-installing the Pulsar II software.
Posted: Tue Dec 19, 2000 2:27 am
by Guest
Subject: Re: Re-install Pulsar II after installing new device?
i don´t think you have to reinstall pulsar after every new installed device.
are you sure that you are using the same pulsar software version like on your old system, on which you previously installed the sts4000 the first time? maybe there is a conflict...
gruß,
Mo
Posted: Tue Dec 19, 2000 3:22 am
by Lotuz
Subject: Same software
Yes, it's the same software. The only thing that's different is the PC.
Posted: Tue Dec 19, 2000 8:38 am
by Guest
Subject: what does
support@creamware.de say?
what does
support@creamware.de say? anything useful? sometimes they are busy, but try it.
Posted: Tue Dec 19, 2000 11:26 am
by Guest
Subject: Re: Re-install Pulsar II after installing new device?
Believe it or not, but re-installing the Pulsar II software did solve my problem! I think this is rather strange, but you won't hear me complain at the moment...
Posted: Wed Dec 20, 2000 2:45 am
by DJKrooz
Subject: Re: Re-install Pulsar II after installing new device?
Nice one - thought it would.
Happy STS using!
Krooz.
Posted: Wed Dec 20, 2000 7:01 am
by Lotuz
Subject: Thankz Krooz!
