Page 1 of 1
Posted: Wed Dec 31, 1969 4:00 pm
by Guest
Has anyone been able to work out how to send program change messages from Cubase to select and change presets in Pulsar. I have given my presets program numbers but when I try to call them up from Cubase...nothing happens....
I'm guessing that I need to send program changes as one byte from the bank section or "send as program change"... but neither works so far... any clues?
Posted: Wed Dec 31, 1969 4:00 pm
by gelder
Subject: program change
do you mean how to change cutoff , velocity etc ?
Posted: Wed Dec 31, 1969 4:00 pm
by AudioIrony
Subject: Re: program change
no, I mean switch between presets via program change
Posted: Wed Dec 31, 1969 4:00 pm
by Guest
Subject: Re: program change
Same problem for me, whats even more annoying is,
sometimes it works (1 of 20 maybe). Is there some
special setup one have to use in order to get prog changes
to work?
Posted: Wed Dec 31, 1969 4:00 pm
by Guest
Subject: Re: program change
I've posted this question a while ago here on this forum because I have the same problem, but no one seemed to be able to tell me anything to solve it. I think we should ask CW about this as I think it's rather rediculous that it only works once in 20 times.
Posted: Wed Dec 31, 1969 4:00 pm
by Guest
Subject: Re: program change
The strange thing about all of this is that I can.. on some synths... get volume change messages to create gate effects... I can sit there and watch the volume knob spin around.... by using the "learn control message" feature and sending the control message data from my sequencer.......
However, I just can't get Pulsar synths to sync to midi clock or respond to program change messages. I was lead to believe that Pulsar integrated seamlessly with Cubase... but unless I'm doing something horribly wrong with either Pulsar midi/sequencer modules or OMS, then CreamWare really need to get their act together. Hmmm... a complete studio on a card .... I don't think so!
Posted: Wed Dec 31, 1969 4:00 pm
by Guest
Subject: Re: program change
Well, yeah normal midi messages sent to the knobs of the synths/fx and mixers all work fine with me too. It's just hte program changes that don't.
Posted: Wed Dec 31, 1969 4:00 pm
by Guest
Subject: Anyone ever got program changes to work ok everytime?