Z--Link & Adat in parallel ?
Posted: Sun May 12, 2019 9:19 am
I like to mess around with my scope on two PCs. ( PC1 with 15DSP-PCI and PC2 with Xite-1 )
As I only use one A16 for my synths, I used a Adat-switch to change PCs.
I now connected zlink between Xite and A16 in parallel to Adat. Now I get lots of crackles on Adat-Ports.
The samplerate settings allows to select Adat for sync, but not on zlink...
Question 1: What's going on/wrong ?
As I also like to exchange project between pcs, the Adat-ports were automatically converted from scope-adat to xite-adat.
But there's no automatic conversion to zlink.
Question 2:
Is there a easy way to migrate the hardware-ports from adat to zlink ?
As I only use one A16 for my synths, I used a Adat-switch to change PCs.
I now connected zlink between Xite and A16 in parallel to Adat. Now I get lots of crackles on Adat-Ports.
The samplerate settings allows to select Adat for sync, but not on zlink...
Question 1: What's going on/wrong ?
As I also like to exchange project between pcs, the Adat-ports were automatically converted from scope-adat to xite-adat.
But there's no automatic conversion to zlink.
Question 2:
Is there a easy way to migrate the hardware-ports from adat to zlink ?