Page 1 of 1
Posted: Tue Dec 04, 2001 11:14 pm
by Eurocide
When I load the Pulsar Mixer 2448, Pulsar crashes during the loading procedure of this device.
My config:
PIII 700 Mhz, 384 MB Ram, ATI Rage 128, Ethernet, Win98 lite, Pulsar 3.01 Pro Pack
Can somebody confirm this? Any ideas?
Thanks,
Eurocide-HQ
Posted: Wed Dec 05, 2001 4:32 am
by huicholity
Hi,
Same thing happen here with a protection error in mscrvt...replacing the windows file with a new one (from Wavelab for example) solve the problem here...
best regards,
[Huicholity]
http://www.huicholity.com
Posted: Wed Dec 05, 2001 8:21 am
by JoeKa
Here, too!
Config: W98SE, P3/500 on Asus P3B-F, 384MB Infineon selected RAM, Ati Radeon VE,...
But: It doesn´t crash always, sometimes it loads normally at once, sometimes I have to relaunch Pulsar one or two times...
What could it be then?
Posted: Thu Dec 06, 2001 12:51 am
by Eurocide
I checked the MSVCRT.DLL and noticed, that it has the actual Version 6.00.8xxxxxx
All appearances of this DLL in my system have this version. No problems with them so far...
Yes, sometimes Pulsar mixer loads normally from time to time.
Eurocide-HQ
Posted: Thu Dec 06, 2001 1:43 am
by kimgr
This seems to be a general 3.01 bug.
It doesn't happen in 3.0 .
Kim.
Posted: Thu Dec 06, 2001 3:42 am
by Eurocide
Sorry, but I had this problem in V3.0, too, not only 3.01
EC-HQ
Posted: Thu Dec 06, 2001 8:07 am
by JoeKa
Ok, I found the reason: it´s not CW´s fault, this msvcrt.dll is a runtime library of Visual Studio 6.0, microsoft knows about similar problems with different other progs and provide an update patch...
Posted: Thu Dec 06, 2001 9:17 am
by subhuman
Never crashed for me on V3 or V3.01, what other software do you have installed?
Posted: Thu Dec 06, 2001 11:04 pm
by Eurocide
I just run Cubase VST 5.1 together with Pulsar. But the error occurs also when nothing else is running. Even after a reboot.
I just downloaded the Library Update directly from MS. We will see what it brings (or not)
EC-HQ
Posted: Fri Dec 07, 2001 8:42 am
by subhuman
If you're running Win98lite, this is probably a cause of running the Win95 shell, put back in the full explorer, it doesn't effect performance and the errors go away
Posted: Mon Dec 17, 2001 4:30 am
by Eurocide
After several tests with the old/new DLLs I found no reconstructable solution for the problem.
Sometimes Pulsarmixer starts without complaint and sometimes it crashes...
No reboot is necessary between two attempts only a Pulsar restart (of course).
Posted: Mon Dec 17, 2001 6:21 am
by JoeKa
Yah, I guess I was a bit too fast with that dll solution. Didn´t work for me either.
But in my case, I found out that pulsarmixer loads 95% sure if I kick my cfos DSL driver before starting pulsar...
<font size=-1>[ This Message was edited by: JoeKa on 2001-12-17 06:24 ]</font>