Page 1 of 1
Adding a new Pulsar Card
Posted: Thu Jul 28, 2016 4:22 am
by Jonathan T
Hi
I currently have a three card system - two Pulsar2 and a Luna2 and I have the v5.1 software with the keyfile for this setup.
I've bought another Pulsar2 on ebay and I want to add it in place of the Luna. It's a while since I did this so what's the procedure - do I email Soniccore with three serial numbers and a request for a new keyfile?
Thanks
Jonathan
Re: Adding a new Pulsar Card
Posted: Thu Jul 28, 2016 4:26 am
by faxinadu
technically if the other card has a keyfile for 5.1 you don't need anything, just pop in the extra card.
Re: Adding a new Pulsar Card
Posted: Thu Jul 28, 2016 4:50 am
by Jonathan T
It's just the card - no keyfile included. The serial number is on the card of course.
Jonathan
Re: Adding a new Pulsar Card
Posted: Thu Jul 28, 2016 8:22 am
by garyb
only one card needs keys if all cards are connected via an S/TDM cable in the same machine. as long as the Luna wasn't the card with the v5.1 keys, you can just remove it and put the new card in it's place. SonicCore doesn't register the cards or the cards' users, so you don't need to contact SC.
Re: Adding a new Pulsar Card
Posted: Sat Sep 17, 2016 9:36 am
by Rigo
Bumping this a bit ...
I have a Pulsar 2 with 5.1 and some plugins, and I bought another 2 Pulsars (with 2 STDM cables for 3 cards) ... how I handle with the plugins that come with the new cards ?
Re: Adding a new Pulsar Card
Posted: Sat Sep 17, 2016 10:51 am
by garyb
just import the new card's keyfile as well.
if the new card's keyfile is not for v5.1, you can request v5.1 keys for the additional plugins by sending a copy of the keyfile to SC.