Page 1 of 1
Re: Sync Pllate Setting Up ETC
Posted: Sat Feb 14, 2015 10:14 am
by garyb
do you have the short cable that connects the syncplate to the card? there is a small 10pin connector on the card for the cable. just connect it, attach the wordclock bnc cable and start Scope. in the samplerate window, make Scope slave and choose bnc as the source.
Re: Sync Pllate Setting Up ETC
Posted: Sat Feb 14, 2015 2:19 pm
by garyb
no, you shouldn't need anything else....
i suppose it wouldn't hurt to run the installer again.
Re: Sync Pllate Setting Up ETC
Posted: Tue Apr 26, 2016 2:14 am
by pranza
maybe it is called Src 6 or Src 7?
Re: Sync Pllate Setting Up ETC
Posted: Tue Apr 26, 2016 6:17 am
by gruebleengourd
pranza wrote:maybe it is called Src 6 or Src7?
The BNC sync is Src 6 on my setup running Scope 5.1
Re: Sync Pllate Setting Up ETC
Posted: Tue Apr 26, 2016 12:40 pm
by garyb
that is correct.
sometimes just pushing a button or two will tell what you need to know.
