Page 1 of 1

Volume control Device

Posted: Wed Oct 15, 2014 6:03 am
by Music Manic
Is there a simple device for Scope that has midi control? I would like to use it between my scope mixer outs and the analogue out destination, so I don't have to keep adjusting my headphone or monitor levels.

Thanks

Re: Volume control Device

Posted: Wed Oct 15, 2014 7:26 am
by dante
Yeah there's a speaker setup device that sends a signal 3 ways with a volume slider for each of the 3 outputs :

http://www.hitfoundry.com/issue_06/freedev2.htm

Re: Volume control Device

Posted: Wed Oct 15, 2014 8:40 am
by Music Manic
Ah Thanks I think I have that somewhere. Does it affect the audio signal in any way with regards to distortion or will I get the clean unadulterated signal?

Thanks

Re: Volume control Device

Posted: Wed Oct 15, 2014 9:06 am
by Music Manic
Is there another site where I can download that device Dante? Link is dead.

Also does Modular have a stereo volume fader?

Thanks

Re: Volume control Device

Posted: Wed Oct 15, 2014 9:10 am
by Music Manic
Ahh! Modular 4 has a Stereo Attenuator Module Device. I will try that.

Knew that upgrade would be useful.

Re: Volume control Device

Posted: Wed Oct 15, 2014 3:28 pm
by dante
Music Manic wrote:Ah Thanks I think I have that somewhere. Does it affect the audio signal in any way with regards to distortion or will I get the clean unadulterated signal?

Thanks
I never had a problem with it - been using it for years, no distortions. Anyway the Modular one should do the job.. There's also one called 'Can Control' but I don't know if it has MIDI

http://www.hitfoundry.com/issue_10/can_ctrl.htm

Re: Volume control Device

Posted: Thu Oct 16, 2014 6:41 am
by Immanuel
You can use the stock Channel for that.