"direct mixer out" set to scope p-plate not remembered
Posted: Thu Dec 23, 2010 1:41 am
in xtc mode the direct mixer output settings are not kept.
is there a setting i must do.
i remember that in the past the xtc ully was also not kept but it was solved after modifying the cset.ini
what about the direct mixer output, which i can select once i open the daw...but after restarting the daw it is blank..and needs to be set again.
????
is there a setting i must do.
i remember that in the past the xtc ully was also not kept but it was solved after modifying the cset.ini
what about the direct mixer output, which i can select once i open the daw...but after restarting the daw it is blank..and needs to be set again.
????