PlanetZ forums - scopeusers.com

Scope Users Community
https://forums.scopeusers.com/

ULLI Setting. What's the Optimal Setting?

https://forums.scopeusers.com/viewtopic.php?t=2965

Page 1 of 1

Posted: Mon Oct 01, 2001 12:47 pm
by braincell
I just noticed when I lowered my ULLI latency the latency in Cubase goes up. Since I am not using hard drive recording at this time I guess I should use the lowest latency I can get away with. I suppose if the latency is too low then Pulsar will crash more often also Cubase. I have it set to 4 miliseconds at 44.1 now. I haven't really tested this yet. What are other people using and thoughts on latency?

Posted: Mon Oct 01, 2001 12:50 pm
by lionel_talkover
The ULLI settings use is 7 ms in 44.1. Set to 4 ms my logic can't playback samples without cracks. With 7 ms, no problem at all.

Posted: Wed Oct 03, 2001 7:19 pm
by halcyonlad
how do i change latency settings in logic in xtc mode?

Posted: Wed Oct 03, 2001 7:34 pm
by subhuman
Inside Pulsar, View, ULLI Settings.
All times are UTC-08:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited