PlanetZ forums - scopeusers.com

Hallo,

If i "Protect" a Device or Module, how can i "Unprotect" it afterwards to accomodate or edit it again ?

I see there is a function to protect my Module, wich i have tried, but i don't find a way to unprotect the Module again.

Any suggestions ?

Thanks in advance, best regards,

Medion.

you have posted in the wrong part of this forum. Try the developers section

Medion wrote:Hallo,

If i "Protect" a Device or Module, how can i "Unprotect" it afterwards to accomodate or edit it again ?

I see there is a function to protect my Module, wich i have tried, but i don't find a way to unprotect the Module again.

according to my limited experience, you cannot.
just save a copy of the work before protecting and exporting the device, or dont' save after protecting it.

Bosone is correct, you cannot unportect a protected device. I always save my project, then optimize, protect and save the device. But I never save a project that is protected because it cannot be worked with after that.

Thanks for the advice.

Regards,

Medion