PlanetZ forums - scopeusers.com

I just bought a second hand pulsar card (4 dsp)
It has 4 adat ports, but in scope 5 i can only see 2!! no adat A and adat B, just adat!

Anybody else experienced this? my guess is that SC forgot to add the extra ports for the card in scope 5.


...........and by the way... what is it again that you type in cset.ini to change the order of the cards?
Thanks alot!

Iirc if you pull in the adat module from a p1 it shows 16 in or 16 outs.Its not like a pulsar 2 or scope with 8 in a-8in b or 8out a-8out b.

that's correct Fluxpod - has been that way since version 3
so switch 2 cards in cset.ini add:
[board0]
boardid=1
[board1]
boardid=0

cheers, Tom

Great! Thanks alot