I am getting pretty good results with help from this group. But now I have a new issue that goes beyond just how do I make it do this.
I am having the sdk crash occasionally. I seems to happen when I am testing out faders/knobs to see if the values are correct. (example trying to manipulate text controls so a fader reflects dbs correctly). What happens is I get a dialog saying and excpetion occurred due to a stack limit of 100. Then it crashes.
WHen I save the device (after optimizing and packing) then use the device in sfp, it will work but will occasionally crash sfp. I have resinstalled the sdk, and created new projects with the same issues.
Anyone know of any kind of mistake you can make in a device that would cause this?
sdk crash
Re: sdk crash
I determine the crash problem. I started the project with an empty synth. I removed two internal modules for input and output. I created my device and exported the inputs and outputs. When done I realized the I had 4 outputs instead of 2, the orignal 2and the 2 I exported. So I deleted the 2 unused outputs. When I do that the final divice will invariably crash sfp when the device is removed from a project.
SO, now I have a device (which I would rather not start over on) that has 2 unused outputs that I cannot remove. I assume these 2 outputs are connected to something, and I must disconnect them before I remove them, but I am not sure how to determine what they are connected to.
SO, now I have a device (which I would rather not start over on) that has 2 unused outputs that I cannot remove. I assume these 2 outputs are connected to something, and I must disconnect them before I remove them, but I am not sure how to determine what they are connected to.
mark winger
Re: sdk crash
That does not make sense!
normally that stack overflow is caused by some control parameter counting in a loop or uncontrolled way.
as for the second pair of outputs that has never happened to me, are they wired to anything in the node window?
normally that stack overflow is caused by some control parameter counting in a loop or uncontrolled way.
as for the second pair of outputs that has never happened to me, are they wired to anything in the node window?