PlanetZ forums - scopeusers.com

Hi,
i would need some help with Pulsar II and Cubase. I need to get all audiosignals from Pulsar into Cubase. Right now i managed to send the Bigmixer's mix out to the ASIO dest. It works fine and i get the Pulsar audio to a Cubase BUS. But how do i set it up if i want all channels from the big mixer to different busses in Cubase so it's possible to add Cubase effects to all Pulsar's sounds?

Thanks!

just open the ASIO-module (rightclick) and tell 'em how many channels you want and restart Cubase that it can initialize the additional inputs and/or outputs.
Happy pulsaring!
Micha

Thanks!!

But where do i find the outputs from Pulsar that i want to send to Cubase? Should i use the R1, R2, R3 etc outputs from the Bigmixer or? I want to be able to send each channel/synthesizer in pulsar to a single mono/stereo channel in cubase to be able to add unique effects in cubase on each channel.

Sorry for asking

Depends on if you want to use Pulsar effects on your parts BEFORE they reach Cubase.

If you don't, then just route the outputs of your synths/samplers directly to the ASIO destination.

It seems that you're rushing things thus forgetting the fact that there are something out there called "manual"

read it, you'll be surpriced how much you can learn!!