Page 1 of 1
Splitting cards, authorization issue
Posted: Wed Jul 29, 2009 3:50 pm
by ElmerJFudd
I have 3 cards (Scope Pro, Pulsar II, and Pulsar I) in a PC.
I've pulled the Pulsar I out and stuck it in a second PC.
I've installed the driver, and am trying to install the 4.0 software?
However, my keyfile (.RGY) will not import properly during installation.
Rather, I get a "Cannot open registry file!" error.
Soniccore have already provided me with the RGY file to install this card separately but I'm stumped.
What may the issue be?
Thanks in advance!
Re: Splitting cards, authorization issue
Posted: Wed Jul 29, 2009 11:09 pm
by garyb
try renaming the file extension to .skf...
Re: Splitting cards, authorization issue
Posted: Thu Jul 30, 2009 8:42 am
by ElmerJFudd
Thanks for the reply, good idea...
The installer does seem to be looking for an skf.
No luck though, getting the same error when trying to load file.
Re: Splitting cards, authorization issue
Posted: Thu Jul 30, 2009 8:48 am
by garyb
open the file with wordpad and be sure that the card's serial number matches the serial number in the keyfile....
Re: Splitting cards, authorization issue
Posted: Thu Jul 30, 2009 8:57 am
by Fluxpod
When i had this prob i had to delete it from the windows known file extensions list.I clicked on "always open with wordpad" once and it showed up as a wordpad document then...the installer couldnt open it.It has to be shown as a Unknown file in windows!Dunno if that helps but it fixed that for me.
Re: Splitting cards, authorization issue
Posted: Thu Jul 30, 2009 10:55 am
by garyb
good info!
Re: Splitting cards, authorization issue
Posted: Fri Jul 31, 2009 8:10 am
by ElmerJFudd
Solved,
Refer to this thread,
http://forums.planetz.com/viewtopic.php?f=1&t=27876
Last solution.
a file gets installed on the highest part of the C: drive during the driver installation.
apparently the installer can't over-write this file.
you have to do it manually, then try loading your key file again.