PlanetZ forums - scopeusers.com

Howdy fellow PZ members!

I need to clear out some Magma product:

• black 68-pin Magma cable + CardBus card, model CBH1F with Volcano logo: $125

• black 68-pin Magma cable + CardBus card, model CBH1F 01-04551-02: $150

• Magma CB1H chassis with power supply, mint condition: $150

100% feedback rating up on Ebay (wmvonbrock). All prices include ground shipping within the continental US
PayPal/postal money orders or trade for/towards the following:

• used Magma EC34 or EC54 (expresscard)

• used/new Barber Electronics BarbEQ guitar pedal (for experimentation with Scope)

• also, a used Magma PCI-E 68-pin host card

Best regards,
cap

(Note: these were used to evaulate various Scope boards, along with a couple other chassis, and they work fine. TI CardBus chipset is a must for best performance! My notebook has a crappy Ricoh CardBus slot - Magma says to avoid them at all costs )

Edit: up on Ebay

I am interested into the ability to run scope on a laptop but I have not researched this much. Is there 3 completes setups here? What is the difference between them?

Magma stuff is good but very pricey imo unless purchased used.

The CB1H supports any half-height card. You'll need a chassis, cable + host card for a complete setup (this stuff is separated for buyer flexibility).

http://www.magma.com

So I need the cb1h and 1 cardbus + cable to run one half-height card, right?

I have 2-pulsar 1, 1-pulsar 2 and a 15-dsp scope card. I know the scope card won't fit. But aren't the pulsars too large also?
A scope home card I know will fit.

Yup

However, for multi-card setups a larger box is a must. Also, the CB1F will fit a PII, 15-DSP card etc.

The CB1H would also be great for starting to play with those cheap UAD-1 cards, now that the UAD-2 line has been released.

The 2-card units actually will fit 3 full length cards with a bit of faux i/o plate fabrication. Unsure about cooling. The 4-card units look like the bomb for a 3 card setup, plenty of space & cooling.

How much for the BarBQ pedal?
If you have it set up on ebay that's fine w/ me also.
That little unit does wonders to clean signals.
I saw them at clubs everywhere in Philly and NYC, but no so much out here?

no i think he wants to buy one

Yup (we traded PMs already & sounds like he's busy with Film & Production training too)

I'm thinking it would be a great as a moderate boost & tone shaper, before an A/D stage. It is getting lots of good reviews.

(BTW - Neutron, thanks for releasing the open sdk devs! I hope to get started with them & the sdk once S/C gets the requisite paperwork. That is a very cool thing, and like someone else posted, Creamware should have had that kind of thing already in the sdk. Looking forward to it )

Edit: up on Ebay