Page 1 of 1
Quick ways to make many connections in the routing window?
Posted: Fri Jan 02, 2009 1:10 pm
by Mike Goodwin
I remember reading in the manual when I first got my Scope card that there was a way to connect all the outs of one device to the In's on another device quickly. But I have looked in the manual and can't find anything like that. I might be going crazy, would not be the first time
I did read the key command section of the manual btw. Are there any other little tips about quick routing thinigs in Scope that people might want to share?
All the best
Re: Quick ways to make many connections in the routing window?
Posted: Fri Jan 02, 2009 1:54 pm
by alfonso
connect out 1 to in 1 and then press "n"
Re: Quick ways to make many connections in the routing window?
Posted: Fri Jan 02, 2009 2:49 pm
by Mike Goodwin
THANK YOU!
Re: Quick ways to make many connections in the routing window?
Posted: Fri Jan 02, 2009 2:59 pm
by at0m
.. and IIRC, Shift-n connect all possible consequent connections.
For a deleted connection, the "n" key works just the same
Re: Quick ways to make many connections in the routing window?
Posted: Tue Jan 06, 2009 10:49 am
by iSiStOy
Ah! didn't know about the delete one and press n! Cool
Re: Quick ways to make many connections in the routing window?
Posted: Wed Jan 14, 2009 3:52 am
by Mike Goodwin
Thanks the shift n is indeed very cool. Makes working much faster
Re: Quick ways to make many connections in the routing window?
Posted: Wed Jan 14, 2009 11:08 am
by Neutron
right click on device to completely replace it with a compatible item.
for instance right click on an ADAT input and chose any other ADAT or Zlink you have available and it will replace it without having to rewire.