PlanetZ forums - scopeusers.com

Hi Guys,

I am making some controller setups and cannot work out how to get the Noah to dump its current CC settings over midi.

Is this possible or is it only possible to output the front encoders?

Cheers

Andy

There is a way to get back the MIDI CC message as I remember I did get them with MIDIOX to monitor the CC to pot mapping to setup a template for the Vectron Beta version. Each time you load a new preset, you get all the CC messages sent to give you the position of the pot for this preset.

For example if you connect MIDI in and out betwween one NOAH and a BCR 2000 you can get the feedback on the ledrings of the BCR2000 encoder at each preset load.

Hi,

Thanks for the reply.

When I change presets I get no midi out from the unit at all, can you remember what to change to get it to do this?

Cheers

Andy

Check the MIDI Manager, the Out ports, buth for the slots and General and also the send setting in the System section of the MIDI Manager.

Hi,

Thanks for the help.

I have it working when you change presets from the Noah front panel now.

When I change presets from the remote software it doesn't work.

Also changing parameters in the remote software doesn't send ccs.

Is this normal.

Cheers

Andy

Even more problems now, not all ccs seem to be sent via hardware midi.

If you use usb midi they seem to all work.

I have tried two different midi interfaces and different cables, very annoying.

Andy

With which plug-in do you make your test ?

HI,

It was prodyssey

Cheers

Andy