Page 1 of 1
S/TDM Connections
Posted: Wed May 28, 2008 4:03 pm
by dokken
Is there a possibility to connect these two scope/home 4.5
boards and use them as one with 6 dsp's ?
Can scope 4.5 software support this ?
How should be 14 dsp power-booster and scope/home 4.5
connected and used as one with 17 Dsp's?
Can this concept work and achieve stability ?
Is there any topic or documentation / manual on this one ?
Posted: Wed May 28, 2008 4:43 pm
by alfonso
STDM connection does exactly this. The system is conceived to allow up to 3 boards to be used in a PCI bus which must be connected by that cable. They are seen from the software as a unique system with the sum of the dsp chips and all the I/O's available. You can't use a multiple setup without the STDM connection.
Posted: Wed May 28, 2008 5:02 pm
by garyb
that's right, for two cards use cannectors A and C on the s/tdm cable.
for the two luna/home cards obviously you connect 1 to 2.
for the Professional and Luna/home cards connect 1 to 6
Re: S/TDM Connections
Posted: Wed May 28, 2008 5:05 pm
by sharc
dokken wrote:Is there any topic or documentation / manual on this one ?
The Scope printed documentation covers this topic briefly (not sure if this is available on the FTP site). If you have any problems, there's plenty more info / help available here on Z.
Posted: Wed May 28, 2008 7:57 pm
by dokken
Thank you gentlemen for help
to better understand sonic/scope
and ex.creamware world.
I'm gonna proceed.
Posted: Sat May 31, 2008 3:25 pm
by dokken
I have a few more questions but i am going to open a proper topic.