Page 1 of 1
Can I change my I/O plate ??
Posted: Tue May 01, 2007 2:11 am
by Stompa81
I was just wondering with my Scope Project card if I can change my classic I/O plate for a "plus" i/o plate??
If it is possible can I buy a plus i/o plate off someone ???
Posted: Tue May 01, 2007 2:37 am
by husker
I've got a Plus plate on my Pulsar 2 which I would quite like to swap for a Classic, and you're not to far across the ditch (i'm in Wellington). PM me if you are interested.
Cheers, Wayne.
Posted: Thu May 03, 2007 11:54 pm
by Stompa81
Wayne I sent u a pm
stardust wrote:it is possible
Is it just a case of simply swapping the plates over ?? Or do you have to re-install scope after the swap aswell??
Posted: Fri May 04, 2007 1:56 am
by hifiboom
not having done it yet
i would say :
no
it has nothing to do with the drivers....
Posted: Fri May 04, 2007 8:51 am
by ali
All Pulsar 2/Scope project I/O plates are Interchangeable
you can swap your PLUS with Classic or Zlink or 24ADAT and vise versa.
Posted: Fri May 04, 2007 2:17 pm
by husker
I hope it works!
I unplugged the i/o plate from my Pulsar 2 and powered it up again (I also have a Pulsar 1 and PowerSampler) - Scope still see's the Pulsar 2, but with no i/o - just acts like a DSP booster.
So I wired my ADA8000 up to Pulsar 1, re-routed and all good to go! This stuff is too smart sometimes. The flexibility we have is amazing.
Anyway, means I can do the swap with Stompa81 without any down time for either of us.
Posted: Fri May 04, 2007 9:59 pm
by Stompa81
Talk about being at the right forum at the right time
Posted: Fri May 04, 2007 10:50 pm
by husker
Most of life's problems can be solved at planetz
Posted: Sat May 05, 2007 5:12 am
by manfriday
I've done it.
It works fine.