PlanetZ forums - scopeusers.com

I would assume you could do this in XTC mode, but can you do it (& if so how) in SFP mode?

(Ok I should probably read the manual, but I'm not at my scope pc right now & I've just thought of this)

Just route your sends via ASIO to your host sequencer (e.g. Cubase), apply your fx and then route back into Scope (again, via ASIO) and mix.

You can use a 'dedicated' fx channel or a normal ASIO channel, I don't think that it matters much. You'd have the fx on 100% wet and then just mix the effected signal back into your mix

thanks, sounds simple, I'll give it a go