Page 1 of 1
Pulsar XTC ASIO - STOOOPID ?
Posted: Sat Feb 03, 2007 9:48 pm
by Scotty
Ok, what happens to the ULL speed if you add an pulsar XTC to to pulsar I system? WHen you add a pulsar II to the a pulsar 1 card you can do lower than 13ms at 44.1 mhz . Will dropping in an XTC do the same? I know that the xtc has no IO but does it have the faster clock?
Posted: Sun Feb 04, 2007 12:17 am
by arela
Only guessing, but could not see what difference IO has to do with this.
Should work as Pulsar2 if the XTC is set to first card.
Posted: Sun Feb 04, 2007 12:47 am
by DSP ADD!CT
i think the pulsar 1s lowest ulli setting is 13ms so if u cascade a pulsar2 then it will still be the same.
only 2nd generation cards can work with lower ulli settings.
cheers
DSP ADD!CT
Posted: Sun Feb 04, 2007 3:47 am
by astroman
regarding latency any 2nd generation card will do 'before' a Pulsar One and give you the lower ULLI values, but there is a certain degree in IO performance.
That was the answer I got from CWA tech support a couple of years ago on exactly the same question.
Yet this setup doesn't seem to work with all mobos (or all cards ?), as recent threads under 'problem solving' show.
cheers, Tom