Page 1 of 1
Attenuator setup in Scope mixer?
Posted: Thu Feb 01, 2007 4:37 pm
by Hangee_77
What dB do you guys normally set on the attenuator fader when mixing in Scope mixer?
hc.
Posted: Fri Feb 02, 2007 5:11 am
by katano
do you mean the master fader or the channel input gain or else?
Posted: Fri Feb 02, 2007 8:05 am
by Hangee_77
yes, the master fader & the channel input gain.
hc.
Posted: Fri Feb 02, 2007 9:22 am
by katano
i usually leave the channel gain at zero while feeding it from cubase via
asio if they're at a good level. then i mix it down to stereo and reduce the
master level only if needed, means some audible clipping occure, it
depends on the mix. mostly between -1 and -4db...
cheers
roman