Page 1 of 1
Master mixer window question.
Posted: Sun Nov 19, 2006 3:36 pm
by areptiledysfunction
When I open the master mixer, it opens to channel one. If I want to send channel 17 to an aux, I have to click the channel number in the lower right hand corner of the master mixer window. The literature I have here is limited at the moment but I will be R'ingTFM next week. In the meantime, is there a shortcut to quickly jump to the channel that I want to process in the master mixer window......like if I want channel 20, I can just type "20" into a field somewhere?
Thanks,
Posted: Sun Nov 19, 2006 8:02 pm
by wayne
Type 20 into that very field you mention (or the one top right), hit enter.
Some textfields in scope don't change or give text cursor when you click - never mind, just type anyway.
Also, if you have channels window open, click on 20 and master follows.
Posted: Sun Nov 19, 2006 9:21 pm
by areptiledysfunction
wayne wrote:Type 20 into that very field you mention (or the one top right), hit enter.
Some textfields in scope don't change or give text cursor when you click - never mind, just type anyway.
Also, if you have channels window open, click on 20 and master follows.
Well...DOH!! It worked. Funny, I did try that first off but nothing happened. Probably just my FU.
Thanks,
Posted: Sun Nov 19, 2006 11:09 pm
by garyb
you can also click, hold and drag the number. that's very fast.
if the channel panel is showing, you can select the channel you want by clicking it's number on the bottom of the strip.
Posted: Mon Nov 20, 2006 12:50 pm
by areptiledysfunction
garyb wrote:you can also click, hold and drag the number. that's very fast.
if the channel panel is showing, you can select the channel you want by clicking it's number on the bottom of the strip.
OK!!!.thanks. I'm getting ready to head to Office Depot right now to get the manual professionally printed.
;o)