PlanetZ forums - scopeusers.com

Posted: **Fri Jul 21, 2006 7:02 am**

hi,
cant figure it out which two are in and which two are out! they all look just same.
thanks

Posted: **Fri Jul 21, 2006 7:25 am**

you adat ins are the sources and your out are the destinations.Try putting something into it you'll soon figure it out.

Posted: **Fri Jul 21, 2006 7:57 am**

the inputs are dark and the outputs show a red light

cheers, Tom

Posted: **Fri Jul 21, 2006 8:34 am**

Please refer to page 3 of the PDF manual under connectors

ADAT in 1 (A)
ADAT out 1

ADAT in 2 (B)
ADAT out 2

<font size=-1>[ This Message was edited by: ali on 2006-07-21 09:35 ]</font>

Posted: **Fri Jul 21, 2006 9:33 am**

Thanks all.
so the 1st one from left is IN-A

thanks again.

PlanetZ forums - scopeusers.com

ADAT i/o of pulsar2