Page 1 of 1
Posted: Tue Apr 11, 2006 8:21 pm
by Chisel
I'm looking for a switch to use in the SFP router for toggling between two audio sources going into the same input.
Thanks,
Chisel
Posted: Tue Apr 11, 2006 9:32 pm
by wayne
Switch-It
I just used the search function and there are some post-SDK devices too, by
Shane White &
Symbiote .
<font size=-1>[ This Message was edited by: wayne on 2006-04-11 22:37 ]</font>
Posted: Tue Apr 11, 2006 11:02 pm
by Chisel
I did a search before posting here and found Switchit and a few others. I'm looking for something that is even simpler (2in->1out). I need a lot of them and Switchit and the others are kind of overkill for my application. I also saw the one by John Bowen, but that is for use in Modular.
Posted: Tue Apr 11, 2006 11:09 pm
by wayne
Ahh - better post in wishlist then
Posted: Tue Apr 11, 2006 11:17 pm
by Chisel
Hmm, if I can have more than two audio inputs and more than four audio outputs in Modular III, then I can create my own switching module using the 2x1 switches.
Posted: Wed Apr 12, 2006 1:30 am
by wayne
Just thinking that myself - try the 8-8 I/O shell.
Posted: Wed Apr 12, 2006 6:05 pm
by Chisel
Thanks. I created an 8x8 module that contains four 2x1 switches. I wired everything up and then added five of these to my project. I then routed all of my audio sources to one set of module inputs and the sequencer sources to the other set. The other side of the modules are all routed into the STM. So basically, I can now use the STM with all my outboard gear and h/w sequencer without having to launch my DAW! The funny is that the switches didn't behave as I thought they would and I don't even need to switch them at all when I do launch my DAW. They basically act as a two to one merge, rather than a switch. There probably is a easier way to do this, but this works!
Peace /
Chisel