Page 1 of 1
Posted: Thu Nov 10, 2005 7:36 am
by irrelevance
I've used this sustain pedal to control my supernova II keyboard for some time, but is there any way of using it to control scope devices?. It's not possible to route audio to midi so either will I need some kind of physical converter?
Posted: Thu Nov 10, 2005 8:19 am
by erminardi
A lot of midi keyboard controller or keyboard Synthesizer accepts Sustain Pedal as signal in and then converts into midi... just use it throug your keyboard, exit with MIDI CC# and then go into Scope.
If I can right remember, the midi control for Sustain is the CC64, but now I'm not shure.
I don't think that you could use directly the pedal into Scope because the pedal is a passive gear (is simply a switch) and it can't send any electrical signal.
Posted: Thu Nov 10, 2005 8:26 am
by irrelevance
Yeh just figurered it out, but thanks. The keyboard does transmit the info .