Posted: Sun Jan 09, 2005 9:43 am
On screen without midi?
PlanetZ forums - scopeusers.com
Scope Users Community
https://forums.scopeusers.com/
is there a way to link faders on CW mixers
Page 1 of 1
Posted: Sun Jan 09, 2005 10:21 am
try a submixer, or use a bus...
Posted: Sun Jan 09, 2005 11:24 am
fader-groups?!
Posted: Mon Jan 10, 2005 5:21 am
That's it (on the STM24/48 anyway).....the little box on the R underneath the channel fader.On 2005-01-09 11:24, AndreD wrote:
fader-groups?!
Posted: Mon Jan 10, 2005 6:22 am
Also on DynamicMixer and STM4896
Posted: Mon Jan 10, 2005 9:08 am
True, concerning STM2448/48/96 check 'Fader Group', manual page 11
One thing is strange tho.
The manual says 'you can assign a channel to one of 4 fader groups.
But there are not 4 but 8 groups!
Btw, you can also create Mute groups.
I forgot about these functions, I should use them!
Wrong forum btw...
<font size=-1>[ This Message was edited by: hubird on 2005-01-10 09:17 ]</font>
One thing is strange tho.
The manual says 'you can assign a channel to one of 4 fader groups.
But there are not 4 but 8 groups!
Btw, you can also create Mute groups.
I forgot about these functions, I should use them!
Wrong forum btw...
<font size=-1>[ This Message was edited by: hubird on 2005-01-10 09:17 ]</font>