Posted: Fri Apr 23, 2004 11:50 pm
It's deja vu reminding me of when I was uprevving from rev. 2.x to 3.x.
I'm noticing that the cset.ini file looks different. On my last cset.ini I had the old tweak of swapping the board ID's to match the order that my boards are installed on the motherboard.
Like this:
[Host-Config]
Numboards=3
Board0=Host
[board0]
boardid=1
[board1]
boardid=0
***
Meanwhile I'm also getting DSP overflow errors with 16 stereo channel ASIO source. I'm unable to connect channels 15 and 16, despite having the correct number of I/O's. My DSP meter only shows about 30% usage.
Does anyone know if there are different setups now for the cset.ini file for multiple boards?
Is anyone noticing different behaviors in the DSP usage?
Thanks,
Greg
PulsarI / SRB/ PowerSampler
I'm noticing that the cset.ini file looks different. On my last cset.ini I had the old tweak of swapping the board ID's to match the order that my boards are installed on the motherboard.
Like this:
[Host-Config]
Numboards=3
Board0=Host
[board0]
boardid=1
[board1]
boardid=0
***
Meanwhile I'm also getting DSP overflow errors with 16 stereo channel ASIO source. I'm unable to connect channels 15 and 16, despite having the correct number of I/O's. My DSP meter only shows about 30% usage.
Does anyone know if there are different setups now for the cset.ini file for multiple boards?
Is anyone noticing different behaviors in the DSP usage?
Thanks,
Greg
PulsarI / SRB/ PowerSampler