Page 1 of 1
Posted: Fri Feb 06, 2004 5:42 am
by samx
hi my lightwave doesn t work on sfp 3.1c.
The others synth are OK. With the lightwave I can see that midi flow is OK but there is no output. I guess this is a graphical Problem or something in the BIOS.
Any Idea?
Thk you all.
Posted: Fri Feb 06, 2004 9:06 am
by at0m
Usually a reinstall of SFP 3.1c fixes such problems.
Backup your presets folder, scopy.rgy, cset.ini and all .pro files from your current SFP directory - they will be overwritten during reinstall. They contain your personal settings and preferences. You can restore them after the (re-)installation.
Good luck!
Posted: Fri Feb 06, 2004 12:50 pm
by samx
Thx for your answer.
I ve already try to reinstall but it 's the same.
I remember one time I had the lightwave only working in XTC config.
Posted: Fri Feb 06, 2004 7:20 pm
by Gockel
Guess it's the same problem that I have... in my case the Auxes of the STM2448 are not working,and reinstalling didn't change anything. Maybe downloading a fresh SFP 3.01c Software can help... hope that it works then. If you find another solution, I'd appreciate you telling me about it.
Bye,
Gockel
Posted: Sat Feb 07, 2004 4:43 am
by bassdude
So when you connect the audio out of the lightwave directly to say the pulsar analog destination you don't get anything?
Posted: Sat Feb 07, 2004 8:03 am
by samx
Exactly if I connect directly the lightwave to the pulsar dest I can t hear anything.
But I remember I used to have it works allright one day. May be with the aux of STM1632... I don't know.