Posted: Fri Dec 12, 2003 2:44 am
What better tip can you give than that?? 
Shayne
Shayne
PlanetZ forums - scopeusers.com
Scope Users Community
https://forums.scopeusers.com/
Buy as many CW cards as possible!
Page 1 of 1
Posted: Fri Dec 12, 2003 8:34 am
Posted: Thu Dec 18, 2003 7:46 pm
yeah, gimme some more !!!
)
)Posted: Tue Jan 06, 2004 4:23 pm
As many as possible? That would be 3.
Posted: Tue Jan 06, 2004 11:44 pm
Yeah, but that's only for the first machine! 
Sam
Sam
Posted: Thu Sep 23, 2004 6:09 am
OK OK .. I followed your advice, now ive got pulsar II + pulsar I card.
Q: How do i make them play nicely and what do i need to do to make them work together?
Q: I bought them both secondhand so there maybe information that i am missing( manuals , instructions, tips and tricks), would love to have them working in my PC
i read that the order is important.
Hmmm help? I asking u guys/gals cos Im a noobie in this world any help would be greatly appreciated!
I read the powerstrip/ doubledawg tip to stop crackles by changing the PCI latency .. Very Interesting!
TIA
Q: How do i make them play nicely and what do i need to do to make them work together?
Q: I bought them both secondhand so there maybe information that i am missing( manuals , instructions, tips and tricks), would love to have them working in my PC
i read that the order is important.
Hmmm help? I asking u guys/gals cos Im a noobie in this world any help would be greatly appreciated!
I read the powerstrip/ doubledawg tip to stop crackles by changing the PCI latency .. Very Interesting!
TIA
Posted: Thu Sep 23, 2004 10:45 am
Well, to use them both together you need an S/TDM cable which you can order from any CreamWare dealer (I like JRRShop personally). The Pulsar1 has one connector, and the Pulsar2 has two, and I don't think it matters which connector on Pulsar2 you plug the cable into. (They're located on the top of the cards.)
The Pulsar2 should be placed further away from the video card than Pulsar 1, as that position on the cable will make Scope detect it as the primary card. Otherwise you have to do cset.ini modifications.
Since you're doing two cards, use the two ends of the cable, not the middle joint.
Boot up your computer and fire away!! Have fun!
Shayne
The Pulsar2 should be placed further away from the video card than Pulsar 1, as that position on the cable will make Scope detect it as the primary card. Otherwise you have to do cset.ini modifications.
Since you're doing two cards, use the two ends of the cable, not the middle joint.
Boot up your computer and fire away!! Have fun!
Shayne
Posted: Fri Sep 24, 2004 4:22 am
Great Stuff! thanks for your help. Its like everything, after awhile it becomes obvious but at the start ... 
Thanks again. read that u guys were helpful so jus checkin hehe!
Thanks
again. read that u guys were helpful so jus checkin hehe!