PlanetZ forums - scopeusers.com

1. First of all I have Pulsar 2 only (slot 3), working in XTC and in SFP mode without problems. Then I have put Pulsar 1 (slot 4)with STDM cable (total 10 processors) and then "XTC CAN'T WORK IN ACCELERATOR MODE". I have tweak all of things that I have readed here, tweaking cset.ini for changing order of P1 and P2. In SFP allways is the same order in Performance window. Pulsar + Pulsar 2 and down of the dialog box is: 1/1,1/2,1/3,1/4,1/5,1/6/2/1,2/2,2/3,2/4,
It seems to be ok, isn't? then I have tweak cset.ini again with changing intBlkSize=x..... but the message is still there when Cubase SX is up and the latency/sync between Pulsar synths and audio is too big. WHAT TO DO NEXT,

2. Next step is UAD-1 (slot 5) NO PROBLEMS.

3. TC Powercore (slot 2) - pops/clicks when I try to put Voice optimised channel strip from Powercore like insert effect in Cubase SX 1.05.61 channel ANY SUGGESTION

P.S. ASUS P4T533/R (RAID disabled); 2,4GHz; 512MB RAMBUS 32bit 1066MHz; NO CONFLICTS, ENOUGH IRQ's

_________________
Regards,
Bobi & KOMPAS band
BLUE production

<font size=-1>[ This Message was edited by: stelibo on 2003-09-12 09:39 ]</font>

I had a problem also with setting board order, in the end i just swapped the cards' slots. 3 minute job.

1. Only swap two of Pulsar cards?
I have tweak now cset.ini with intBlkSize=512. This is 13 ms latency. Enything down from 512 is cset.ini instalation error. But now ...ACCELERATOR... mesage is gone. I think that there is error because cset.ini load Pulsar 1 first even in the order in my SFP window is 1/1-1/6; 2/1-2/4. So as I know Pulsar 1 have something about 13 ms latency than intBlkSize=512 is 13 ms and no ...ACCELERATOR... message? So for now the problem is latency of 13 ms only.

Do you know some other way to changing order of slots, I'm just asking, maybe some windows or BIOS tweak? I have XP pro.

2. I have another question. I know that I can route signal from Cubase SX to ADAT module (my external Behringer DDX3216) when I am in XTC mode, but can I route all 32 channels from Pulsar 1 and Pulsar 2 together?If yes how?