Page 3 of 3
Re: !!!!!!!!! WAVELAB 7 & SCOPE ISSUE RESOLVED !!!!!!!!
Posted: Fri Feb 19, 2016 4:34 pm
by JoPo
I'd like to know if you have this message when you load wavelab 7.2.1. And wavelab work perfectly with asio after clicking 'ok'...
Here :
- asio wl.png (6.61 KiB) Viewed 1814 times
Do you know how to kick the message in its ass ? (Asio source & dest ARE present in my project !)
Thanks..
Re: !!!!!!!!! WAVELAB 7 & SCOPE ISSUE RESOLVED !!!!!!!!
Posted: Sat Feb 20, 2016 3:21 am
by faxinadu
works here! nice one
Re: !!!!!!!!! WAVELAB 7 & SCOPE ISSUE RESOLVED !!!!!!!!
Posted: Sat Feb 20, 2016 3:27 am
by JoPo
It works here too but that message is still here... And as I just format / reinstall W7 on may pc, I was full of hope it would disapeared and go back to the messages country, but...
Re: !!!!!!!!! WAVELAB 7 & SCOPE ISSUE RESOLVED !!!!!!!!
Posted: Sat Feb 20, 2016 10:03 am
by garyb
that's after the patch?
Re: !!!!!!!!! WAVELAB 7 & SCOPE ISSUE RESOLVED !!!!!!!!
Posted: Sat Feb 20, 2016 10:35 am
by faxinadu
garyb wrote:that's after the patch?
here yes. didn't work before (would not even load, was hanging/crashing on load) and after the patch all good.
unrelated: i miss old pre-bullshit soundforge so much :/
Re: !!!!!!!!! WAVELAB 7 & SCOPE ISSUE RESOLVED !!!!!!!!
Posted: Sat Feb 20, 2016 11:51 am
by JoPo
garyb wrote:that's after the patch?
Yes, after the patch...