SFP 3.1 + Logic Platinum 5.1.2 (newbie)

ratkinson · Post by **ratkinson** » Thu Jun 06, 2002 8:46 am

Pleased it has worked for you but I wouldn't advise giving the program anymore priority, if things are working ok at high, then leave it at that.
Somebody with better knowledge of thread priorities might be able to answer this better, but I would reckon real time might be the priority that some of the operating system has, so you would probably find it would go the other way and start running worse than at normal priority.

Fabian · Post by **Fabian** » Sat Jun 08, 2002 2:27 pm

he Ratkinson

Is there a way to make the priority setting permanent, I can set it to "higher than averege " any higher makes my LAP stutter, but I use a lot of software synths and samplers. I'm runnin XP Pro, LAP 5.1.3 and SFP 3.1, the perfect combination!!!!

ratkinson · Post by **ratkinson** » Sat Jun 08, 2002 10:54 pm

Fabian check this thread out it explains how to include the priority in the command line for starting up logic
http://www.planetz.com/forums/viewtopic ... 88&forum=3
As regards setting your system higher than AboveNormal, all I can say is this priority changing is suck it and see stuff. This might be why Emagic set the priority at Normal, because it is the safest setting. Never seen any official statement from the Emagic programmers on this issue, which is a shame because it is the one thing that lets Logic down.