Pulsar + Emu Xtreme Lead

Shifty · Post by **Shifty** » Wed Apr 18, 2001 2:59 am

I'm currently linking my Emu XL Turbo (excellent!) to my Pulsar I (latest software update) via the SPDIF.

All is generally well however sometimes when I load up a project the SPDIF connection only emits crackles, which can usually be solved by alternating between Master and Slave a few times. Even worse, every now and again during playback or recording the system freezes up for a few seconds - occasionally this also leads to stuck notes on the XL1. V. annoying!

Anyone else come across this? Any solutions?

Cheers.

subhuman · Post by **subhuman** » Wed Apr 18, 2001 9:35 am

PulsarII SPDIF fixes this. Other than that, my only suggestion would be to use the Analog I/O on your Pulsar I. I have only been able to reliably use EITHER the SPDIF/i OR the SPDIF/o, but not both at the same time.

At one point, someone said they were using both SPDIF/i/o just fine without clicks with a Pod. I was a little surprised, I thought that was impossible...

Anyone else?