Page 1 of 1
Doubts about updating to Scope v.7
Posted: Wed Apr 18, 2018 12:19 am
by ondas
Can work well in 64-bit system the Scope v.7 in XTC mode (as vst integration in cubase)?. Also if the STS samplers work in 64 bit system. It's really worth it to upgrade to Scope v.7?
Re: Doubts about updating to Scope v.7
Posted: Wed Apr 18, 2018 6:44 am
by Ripper
XTC and STS DON'T work in x64 at this moment. Everyone is expecting that to hapen anytime in a future 7.x update. Will it hapen? I don't know.
Re: Doubts about updating to Scope v.7
Posted: Wed Apr 18, 2018 7:10 am
by ondas
ok, we'll have to wait then...
Re: Doubts about updating to Scope v.7
Posted: Wed Apr 18, 2018 10:11 am
by garyb
yes, it will happen. v7.1 is nearly ready, i believe....
if the STS is your main concern, you should wait.
Re: Doubts about updating to Scope v.7
Posted: Wed Apr 18, 2018 12:32 pm
by Bud Weiser
garyb wrote: ↑Wed Apr 18, 2018 10:11 am
yes, it will happen. v7.1 is nearly ready, i believe....
if the STS is your main concern, you should wait.
Patience and perseverance are the primate´s success story !
Bud
Re: Doubts about updating to Scope v.7
Posted: Wed Apr 18, 2018 11:25 pm
by Xite Knight v2.0
If you buy and install the current v7, part of your Xite hardware will be rendered useless, namely, the BNC port intended for receiving external wordclock
Re: Doubts about updating to Scope v.7
Posted: Thu Apr 19, 2018 12:03 am
by garyb
not for long...
Re: Doubts about updating to Scope v.7
Posted: Thu Apr 19, 2018 2:02 am
by ondas
I am an exemplary primate patient, Bud.... Well, I hope so, although I do not use BNC
Re: Doubts about updating to Scope v.7
Posted: Thu Apr 19, 2018 4:35 am
by Xite Knight v2.0
garyb wrote: ↑Thu Apr 19, 2018 12:03 amnot for long...
Sounds awesome