STM mixer Board IDs
Posted: Wed Sep 07, 2016 8:01 am
I never used to change it, but I tryied to put STM 2448 all channels to Board 2...
DSP load decreased a little,
can load 7 masterverbs classic WITHIN a huge project of 48 asios, 5 synths and all connected...(Before I could load only 2 masterverbs)
can reach higher polyphony of synths...
Scope14dsp+pulsar6DSP here and set pulsar6DSP as 1st board in cset.ini because scope loads faster this way
DSP load decreased a little,
can load 7 masterverbs classic WITHIN a huge project of 48 asios, 5 synths and all connected...(Before I could load only 2 masterverbs)
can reach higher polyphony of synths...
Scope14dsp+pulsar6DSP here and set pulsar6DSP as 1st board in cset.ini because scope loads faster this way